Alcatel-Lucent 7302 Information Manual page 730

Intelligent services access manager

Hide thumbs Also See for 7302:

Table of Contents

NTP 122 — Replace an I-010G-B, I-020G-M, or I-040G-B indoor ONT

Safety information

Read the following safety information before replacing the unit.

Use this procedure to replace an I-010G-B, I-020G-M, or I-040G-B indoor ONT.

Deactivate the ONT services (DLP 131).

If you are using the SLID feature, this step is not required. The ONT and the

services can remain in service (IS).

Power down the ONT unit by using the ON/OFF power switch.

Disconnect the Ethernet, fiber optic, and power cables from the ONT (DLP 132).

For the location of the ports on the ONT; see Figure

November 2013

Danger — Observe the local and national laws and regulations that

may be applicable to this installation.

Warning — This equipment is ESD sensitive. Proper ESD protections

should be used when removing the fiber access cover of the indoor ONT.

Caution — Keep indoor ONTs out of direct sunlight. Prolonged

exposure to direct sunlight can damage the unit.

Note — Observe the following:

The indoor ONT should be installed in accordance with the

applicable requirements of the NEC or CEC. Local authorities and

practices take precedent when there is conflict between the local

standard and the NEC or CEC.

The indoor ONT must be installed by qualified service personnel.

Indoor ONTs must be installed with cables that are suitably rated

and listed for indoor use.

I-010G-B, I-020G-M, and I-040G-B detailed

unit data sheet for the temperature ranges for ONTs.

Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02

specificationsin the

3FE 55873 AAAA TCZZA

ONT Product Information Guide