Sip Data Model And Xml Profiles; Configuration Profile In Sip Modes - Alcatel-Lucent 7302 Information Manual

The ONT can download the appropriate configuration profile using the FTP when
the ONT does not have the specified file name among its embedded configuration
profiles. The downloaded configuration profile is stored in flash memory and can
survive ONT restarts, software downloads, and software activation. Because the
ONT does not re-download a file automatically, any change to the contents of an
existing file on the file server has no impact on in-service ONTs.
To activate a new profile, you must use a different file name on the FTP server. VoIP
service on each ONT must be provisioned with the new file name. The ONT
automatically deletes a previously downloaded file with a name that is no longer
provisioned.

Configuration profile in SIP modes

In the SIP modes, additional data in the configuration profile may be used to
provision SIP services as part of the FTP download data. Section
additional provisioning data. The use of a configuration profile to provision SIP
services is a provisioning option at the ONT.
5.7

SIP data model and XML profiles

There are different device, application, and user profiles for each line of an ONT.
There are additionally local network profiles and vendor specific profiles that apply
to the device. The ONT or MDU must process sets of data that define both the device
as a single unit, and per line. Each profile consists of profile data sets that are a
logical division of properties: local network, device, user, and service.
The distinct sets of data are contained in XML files that are downloaded to the ONT
or MDU. In order for SIP configuration to work correctly in different countries,
XML download files are used. These XML files contain:
•
CDE data related to hardware settings specific to a country, such as tone values
and ringing cadences. Such CDE data should not be configured in most cases.
•
SIP provisioning data, related to SIP-specific configuration parameters, allowing
for per-ONT and per-POTS line configurations. SIP provisioning data can be
configured using the XML file. When using a system that supports
standards-based OMCIv2, you can use TL1 or CLI to configure equivalent
parameters when applicable.
Figure
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
5-10 shows the how the data in the XML files is applied to the device.
5 — VoIP overview
5.7 summarizes this
November 2013 5-23