Alcatel-Lucent 7302 Information Manual page 413

Parameter Description
etsi_ch_release_hel This parameter contains the
d_call service code to be used to
release the held session during a
consultation call. If this
parameter is not configured or is
configured to contain the empty
string, the ONT disables the
functionality. Valid values shall
be of the form "Rd", where d
represents '0'-'9' or '*' or '#'. An
invalid value will cause the ONT
to act as if this parameter was
not configured. This parameter
only has meaning if the
enable_esti parameter is set to
"yes". The default is an empty
string.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
etsi_3wc_split_prec This parameter contains the
onf service code to be used to split a
3-way call and return to the
pre-conference state. If this
property is not configured or is
configured to contain the empty
string, the ONT shall disable this
functionality. Valid values shall
be of the form "Rd", where d
represents '0'-'9' or '*' or '#'. An
invalid value will cause the ONT
to act as if this parameter was
not configured. This parameter
only has meaning if the
enable_esti parameter is set to
"yes". The default is an empty
string.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
enable_call_hold_to This parameter controls whether
ne or not the ONT will play the call
hold tone to the user when the
associated RTP session is inactive
or "sendonly". This parameter
only applies when the
enable_esti parameter is set to
"yes". The default is "no"
etsi_recall_dial_ton This parameter contains the
e_name name of the tone to be played to
indicate to the user that mid-call
dialing is allowed. Possible
values are "DialTone" or
"RecallDialTone". This
parameter only applies when the
enable_esti parameter is set to
true. The default is
"RecallDialTone".
(25 of 30)
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Mode Mode Device
1 2
N Y All
except
package
C, D,
and E
N Y All
except
package
C, D,
and E
N Y All
except
package
C, D, E,
and
I-240W-
S ONT
N Y All
except
package
C, D, E,
and
I-240W-
S ONT
November 2013
5 — VoIP overview
OMCIv2 TL1 or CLI
support? parameters
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
5-67