Alcatel-Lucent 7302 Information Manual page 830

NTP 134 — Replace an I-010S-P indoor or O-010S-P outdoor ONT
Safety information
Read the following safety information before replacing the unit.
Procedure
Use this procedure to replace an I-010S-P indoor or O-010S-P outdoor ONT.
1 Deactivate the ONT services (DLP 131).
If you are using the SLID feature, this step is not required. The ONT and the
services can remain in service (IS).
2 Disconnect the fiber optic cable from the ONT. For the location of the ports on the
ONT; see Figure
SC/UPC connector
3 Disconnect the old ONT from the SFP cage of the residential gateway. Connect a
new unit.
NTP 134-2 November 2013
Danger — Observe the local and national laws and regulations that
may be applicable to this installation.
Warning — This equipment is ESD sensitive. Proper ESD protections
should be used when connecting or removing the cables to or from the
ONT.
Caution — Keep ONTs out of direct sunlight. Prolonged exposure to
direct sunlight can damage the unit.
Note — Observe the following:
The ONT should be installed in accordance with the applicable
•
requirements of the NEC or CEC. Local authorities and practices take
precedent when there is conflict between the local standard and the
NEC or CEC.
The ONT must be installed by qualified personnel.
•
See the I-010S-P and O-010S-P unit data sheet
•
ranges for ONTs.
NTP 134-1.
Figure NTP 134-1: I-010S-P indoor or O-010S-P outdoor ONT connections)
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
for the temperature
SFP connector
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
23149