Alcatel-Lucent 7302 Information Manual page 491

3 Enable one of the following radio buttons to set the Mode of the SLID:
•
•
•
4 Enable one of the following radio buttons to set the String format:
•
•
5 Type the SLID in the SLID Value box.
6 Click on the Apply button to apply the SLID to the ONT. The Set SLID dialog box
opens, as shown in Figure 6-36.
7 Click on Yes to set the SLID to its new value.
The status bar displays the message "The slid setting has been applied!".
8 Connect the PON optical cable to the ONT.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Volatile—In volatile mode, the SLID at the ONT returns to its default value
after the ONT is powered off and on. A volatile SLID is always delivered to the
P-OLT in the proprietary mode, which uses the proprietary PLOAM message.
Permanent—In permanent mode, the SLID at the ONT is stored in non-volatile
mode, and is delivered to the P-OLT in proprietary mode, which uses the
proprietary PLOAM message. A non-volatile SLID retains its configured value
after the ONT is powered off and on.
Registration—In registration mode, the SLID at the ONT is stored in
non-volatile mode, and is delivered to the P-OLT in registration ID mode, which
uses the password PLOAM message defined in G.984.3. A non-volatile SLID
retains its configured value after the ONT is powered off and on.
Hexadecimal—20 characters of 0 to 9 and usually a to f or, A to F, with zeroes
appended to a length of 20 characters
Alphanumeric—up to 10 ASCII characters
Note — The default value is alphanumeric.
Figure 6-36 Set SLID dialog box
6 — ONT management using an ONT interface
November 2013 6-59