Alcatel-Lucent 7302 Information Manual page 764

NTP 125 — Replace an I-010G-P, I-020G-P, or an I-040G-P indoor ONT
3 Replace the ONT with a new unit:
a
b
4 Connect the Ethernet cables as required to the RJ-45 ports (DLP 101).
a
b
c
5 If required, have approved service personnel who are trained to work with optic
fiber clean the fiber optic connection. See DLP
fiber optic handling, inspection, and cleaning.
6 Connect the SC/APC fiber optic cable (DLP 125).
7 Install the power supply according to manufacturer specifications.
8 Connect the power cable to the ONT unit power connector as shown in
Figures
NTP 125-4 November 2013
On a flat surface, such as a desk, substitute a replacement ONT for the old
ONT; go to step 4.
Note — The I-020G-P and I-040G-P cannot be stacked with another
ONT or with other equipment. The ONT mounting requirements are:
allow a minimum 100 mm clearance above the top cover
•
allow a minimum 50 mm clearance from the side vents
•
do not place any heat source directly above the top cover or below
•
the bottom cover
On a wall.
i Slide the old ONT upward and then away from the two mounting screws
until the ONT is free of the wall.
ii Install the replacement ONT following the wall mounting instructions
for an I-010G-P, I-020G-P, or I-040G-P indoor ONT (DLP 122).
For the I-010G-P indoor ONT, connect one cable.
For the I-020G-P indoor ONT, connect two cables.
For the I-040G-P indoor ONT, connect four cables.
Danger — Fiber optic cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
Note — Observe the following:
Units must be powered by a Listed or CE approved and marked
•
limited power source power supply with a minimum output rate of
12 V dc, 1.25 A.
NTP 125-1, NTP 125-2, and
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
134 for more information about
NTP 125-3.
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide