6 — ONT management using an ONT interface
Procedure using butt set or telephone for Package D ONTs
The following procedures provide the steps to enter a SLID at the Package D ONT
(I-240G-R or O-240G-P ONT) using a butt set or telephone.
Procedure 6-50 To enter the SLID using a butt set or telephone
1
Connect the power cable to provide power to the ONT.
2
Disconnect the PON and connect the butt set or telephone to the first POTS port
on the ONT.
3
Reset the ONT by pushing the reset button for over five seconds.
4
Wait for the green POTS LED on the ONT to start flashing (0.7 second on and 0.7
second off).
5
Take the butt set or telephone off-hook.
6
Perform one of the following steps to activate the dial tone (Frequency: 450Hz,
continue):
a
b
7
After the dial tone is activated, perform one of the following steps to dial the SLID
value:
a
b
6-68
November 2013
Note —
To use a butt set or telephone:
•
The ONT must be disconnected from the PON optical cable.
•
The butt set or telephone must be connected to the first POTS port
on the ONT.
•
The SLID must be in ASCII or hexadecimal format.
For an ASCII SLID/Password, dial "*0".
For a Hexadecimal SLID/Password, dial "*L".
The special number can be changed in different scenarios with different
images loads.
For an ASCII SLID/Password, dial twice the SLID value up to 10 digits long with
a "#" ending each time.
The two passwords must be the same. Only digits in the range of 0 to 9 are
accepted.
For a hexadecimal SLID/Password, dial twice the SLID value up to 20 digits
long with a "#" ending each time. Only digits in the range 0 to 9 are
accepted.
The two passwords must be the same. Only digits in the range of 0 to 9 and
"1" and "6" (representing the letters "A" to "F") are accepted.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01
3FE 55873 AAAA TCZZA
ONT Product Information Guide