Ntp 130-2: I-010G-U Indoor Ont 3Fe 55284 Aa Variant Connections - Alcatel-Lucent 7302 Information Manual

NTP 130 — Install an I-010G-U indoor ONT
Figure NTP 130-2: I-010G-U indoor ONT 3FE 55284 AA variant connections
SC/APC connection
Ethernet
connection
7 Verify that the unit is powered. If there is no power, press the Power button.
8 Route the data cable to the RJ-45 Ethernet port at the back of the ONT (DLP 101).
9 Connect the SC/APC fiber optic cable (DLP 125).
10 If used, configure the SLID (DLP 129).
11 If necessary, reset the ONT (DLP 126).
12 Verify the ONT LEDs.
13 Activate and test the services (DLP 128).
14 STOP. This procedure is complete.
NTP 130-4 November 2013
L A
N
P O
W E
R
O N
/ O F
F
Power
connection
Power
button
Danger — Fiber optic cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
s e t
R e
i t c h
S w
D
L E
Reset
button
LED
Switch
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
23696