Alcatel-Lucent 7302 Information Manual page 388

5 — VoIP overview
Parameter Description
enable_info_bas This parameter specifies whether
ed_dtmf the voice client transmits DTMF
digits in INFO method SIP messages
rather than inband or via RFC 2833
signaling. When enabled, this
parameter takes precedence over
the enable_rfc2833 parameter. The
content type for the INFO messages
is controlled by the
content_type_for_info parameter.
The default value is "no" (disabled).
content_type_fo This parameter specifies the content
r_info type to be sent in INFO messages that
carry DTMF tones and flash hook
events. The two supported values for
this parameter are
"audio/telephone-event" and
"application/broadsoft". If an
unrecognized value is specified, the
default value is used. The default
value is "application/broadsoft".
default_packeti This parameter specifies the rate at
zation_interval which the ONT generates RTP frames
if the far end does not request a
specific rate during the SDP
offer/answer phase of establishing a
call. The default is 10 milliseconds
when using FTP download and 20
milliseconds when using iConfig to
configure SIP.
ptime_symmetri Specifies control over the
c interpretation of the
packetization_interval and
default_packetization_interval
parameters. The parameter accepts
two values: no_symmetry (default)
and far_end_symmetry. For further
details see those parameters.
annexb_in_sdp Specifies the appearance of the
annexb parameter in the SDP during
negotiation of G729 as a codec as
follows. If enable_vad is set to
Yes/True/1, then the string
a=fmtp:18 annexb=yes is added to
the SDP. When set to No/False/0,
then the string a=fmtp:18 annexb=no
is added to the SDP. If the SDP codec
list does not include G.729 or this
parameter is set to False/No/0, then
the annexb text is not added to the
SDP under any circumstances. The
default is No/False/0.
(4 of 5)
5-42 November 2013
Mode
1
Y
Y
Y
N
N
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Mode Device OMCIv2
2 support?
N All No, value
except is derived
package from
C, D, E, FTP/defau
I-240W- lt line
S ONT profile.
N All No, value
except is derived
package from
C, D, E, FTP/defau
I-240W- lt line
S ONT profile.
Y Package No, value
A, B, H, is derived
I-240W- from
S ONT FTP/defau
only lt line
profile.
Y All No, XML
except developed
package for
C, D, E, specific
I-240W- customer
S ONT interop
Y All No, value
except is derived
package from
C, D, FTP/defau
and E lt line
profile.
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
TL1 or CLI
parameter
N/A
N/A
N/A
N/A
N/A