Alcatel-Lucent 7302 Information Manual page 732

Intelligent services access manager

Hide thumbs Also See for 7302:

Table of Contents

NTP 122 — Replace an I-010G-B, I-020G-M, or I-040G-B indoor ONT

If required, have approved service personnel who are trained to work with optic

fiber clean the fiber optic connection. See DLP

fiber optic handling, inspection, and cleaning.

Connect the SC/APC adaptor to the fiber optic port (DLP 125).

Connect the power cable with an 8-pin Molex connector to the ONT unit.

November 2013

Danger — Fiber optic cables transmit invisible laser light. To avoid eye

damage or blindness, never look directly into fibers, connectors, or

Warning — Be careful to maintain a bend radius of no less than 1.5

inches (3.8 cm) when connecting the fiber optic cable. Too small of a

bend radius in the cable can result in damage to the optic fiber.

Warning — To avoid the possibility of damage to the pins on the power

cable connector, carefully align the pins on the connector on the cable

with the pin holes in the power connector on the ONT before making the

connection. The pin hole configuration in the power connector on the

ONT is shown in Figure

Molex connector is shown in Figure

Note — When the I-040G-B ONT is used with the Delta DUPS-1215 4.5Ah

UPS at ac line voltages above 200 V ac (either 50 or 60Hz), then the dc

power cable must be equipped with an external clamp-on ferrite

[Fair-Rite 0431167281 (1AB 09397 0026)]. The ferrite must be installed

closer to the UPS than the ONT on the dc power cable.

Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02

for more information about

while the pin arrangement on the

3FE 55873 AAAA TCZZA

ONT Product Information Guide