Alcatel-Lucent 7302 Information Manual page 1030

NTP 158 — Replace an I-211M-H indoor ONT
11 If required, clean the fiber optic connection using one of the following two
methods:
a
b
12 Connect the OptiTap (DLP 124) fiber optic cable.
13 Verify the ONT LEDs, voltage status, and optical signal levels (DLP 127).
14 Activate and test the services (DLP 128).
15 Close the TELCO access door on the ONT and secure using the TELCO 216 tool.
16 Close the left customer access door on the ONT.
17 Close the front cover on the cabinet/enclosure.
18 STOP. This procedure is complete.
NTP 158-4 November 2013
If you are approved service personnel, use authorized practices to handle,
inspect, and clean the fiber optic connection.
If you are not approved service personnel, have approved service personnel
trained to work with optic fiber clean the fiber optic connection.
See DLP 134 for more information about fiber optic handling, inspection, and
cleaning.
Danger — Fiber optic cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide