Alcatel-Lucent 7302 Information Manual page 1057

b
6 Review the connection locations for the following ONT configurations:
•
•
•
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
vii Bolt the outdoor enclosure to the four mounting points on the cable
storage compartment using the supplied #8-16 X 1/2 self tapping
screws; see Figure
viii Position the I-211M-L indoor ONT within the outdoor enclosure, as
shown in Figure NTP
ix Secure the I-211M-L indoor ONT within the outdoor enclosure.
Note — Observe the following:
Do not overtighten the ONT bracket when securing the I-211M-L
•
indoor ONT to the outdoor enclosure. The unit can become skewed
and compromise the environmental seal of the ONT mounted in the
outdoor enclosure.
x Go to step 6.
If you are not using an FSST:
i Open the TELCO access cover on the outdoor enclosure after loosening
the TELCO 216 screw.
Note — Observe the following:
The TELCO access cover of the outdoor enclosure must be open to
•
access the three mounting holes used to secure the outdoor
enclosure to the wall.
ii Secure the outdoor enclosure to the mounting area at the subscriber
premises. Use the appropriate hardware as defined by local installation
practices. Mount the outdoor enclosure using the specified mounting
holes.
iii Position the I-211M-L indoor ONT within the outdoor enclosure, as
shown in Figure NTP
iv Secure the I-211M-L indoor ONT within the outdoor enclosure.
Note — Observe the following:
Do not overtighten the ONT bracket when securing the I-211M-L
•
indoor ONT to the outdoor enclosure. The unit can become skewed
and compromise the environmental seal of the ONT mounted in the
outdoor enclosure.
v Go to step 6.
Figure NTP 160-6 for the I-211M-K ONT
Figure NTP 160-7 for the I-211M-L ONT within an outdoor enclosure
Figure NTP 160-8 for the I-211M-L ONT within a Just Inside enclosure
NTP 160 — Install an I-211M-K or I-211M-L indoor ONT
NTP 160-4.
160-7.
160-7.
November 2013 NTP 160-9