Alcatel-Lucent 7302 Information Manual page 416

5 — VoIP overview
Parameter Description
enable_service_in_r Specifies whether the ONT
emote_hold supports supplementary services
such as three-way calling, call
hold display, and call transfer
when the call session is remotely
held.
The options are True/1/Yes and
False/0/No. If this parameter is
set to True, then ONT supports
the supplementary services. The
default is False. This attribute is
only supported in XML R4.4 and
later.
All lines of I-240W-S ONT should
be configured the same.
service_code_enabl Specifies the feature access
e_warm service code used by subscriber
to activate warmline. The user
agent must support at least two
service codes, as is typical in
most dialing plans. The default is
*53*. This reflects that fact You
can configure the parameter
when the enable_warmline
parameter is set to Subscriber.
service_code_disabl Specifies the feature access
e_warm service code used by subscriber
to deactivate warmline. The user
agent must support at least two
service codes, as is typical in
most dialing plans. The default is
#53#. This reflects that fact You
can configure the parameter
when the enable_warmline
parameter is set to Subscriber.
osi_timer Specifies the open switch
interval duration. The option is a
number from 0 to X, which
represents milliseconds. The
default is 900.
When set to 0, the ONT starts the
permanent signal treatment
immediately after the release
timer expires after a BYE is
received for an
incoming/outgoing call.
When set to non-zero, then after
release timer expires, the ONT
removes the loop current for the
specified time and then starts
the permanent signaling
treatment.
(28 of 30)
5-70 November 2013
Mode
1
N
N
N
N
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Mode Device OMCIv2
2 support?
Y All No, value is
except derived
package from
C, D, FTP/default
and E line profile.
Y All No, value is
except derived
package from
C, D, E, FTP/default
and line profile.
I-240W-
S ONT
Y All No, value is
except derived
package from
C, D, E, FTP/default
and line profile.
I-240W-
S ONT
Y All No, value is
except derived
package from
C, D, FTP/default
and E line profile.
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
TL1 or CLI
parameters
N/A
N/A
N/A
N/A