Ntp 151-1: I-110G-P Indoor Ont Connections - Alcatel-Lucent 7302 Information Manual

6 Connect the POTS cables to the RJ-11 ports (DLP 123).
7 Connect the Ethernet cable to the RJ-45 port (DLP 101).
8 Connect the SC/APC fiber optic cable (DLP 125).
9 Install the power supply according to manufacturer specifications.
10 If used, configure the SLID (DLP 129).
11 Verify the ONT LEDs, voltage status, and optical signal levels (DLP 127).
12 Activate and test the services (DLP 128).
13 STOP. This procedure is complete.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Figure NTP 151-1: I-110G-P indoor ONT connections
G E 3
G E 4
Ethernet (GE)
port RJ-45
POTS
port RJ-11 connector
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
Note — Observe the following:
Units must be powered by a Listed or CE approved and marked
•
limited power source power supply with a minimum output rate of
12 V dc, 1.25 A.
NTP 151 — Install an I-110G-P indoor ONT
P W R
Power SC/APC
connector
November 2013
21546
NTP 151-3