Alcatel-Lucent 7302 Information Manual page 381

Parameter Description
contact_uri_use Mandatory parameter that is the user
r name portion of the contact URI that
represents the port on behalf of
ContactURIUser
which the user agent acts. The user
name of the contact URI is the value
of the contact_uri_user property.
The host value portion of the contact
URI is the numeric IP address of the
user agent. The contact URI is
registered against the AOR. This is a
string of up to 99 characters and a
required parameter. The FTP XML
name of this parameter is shown as
ContactURIUser.
When the string autofill is used, this
keyword substitutes a new
contact_uri_user value, taking the
form:
CLIENTID + PORT#
where
CLIENTID is the TL1 and OMCI
configured value for CLIENTID
PORT# is the numeric port value,
from 1 to n, where n is the numeric
port number for the POTS line
The CLIENTID and PORT# values are
concatenated, with no white space
or other delimiters between them
Autofill is not supported on some
devices. Contact your support
representative for more information.
For other devices, the contact URI is
a "sip" URI whose user name is the
value of the contact_uri_user
property and whose domain is the
FQDN of the user agent, if available,
otherwise the numeric IP address of
the user agent. The Contact URI shall
be registered against the AOR.
For I-240W-S ONTs, if
contact_uri_user="autofill", user
part of AOR from OMCIv2
configuration will be used.
primary_identity Specifies up to 10 identity data sets
may be associated with a single voice
line. If more than one data set is
specified, only one should be
specified as the primary identity.
The primary identity is the one to be
used in outgoing calls and
subscriptions from the line with
which it is associated. If more than
one identity data set has this
property set to true/1/yes or if none
does, the voice client may use any of
the configured identities. The
default is false/0/no.
(3 of 3)
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Mode Mode Device
1 2
Y Y Package
A, B, H,
I-240W-
S ONT
only
Y Y All
except
package
C, D, E,
I-240W-
S ONT
only
November 2013
5 — VoIP overview
OMCIv2 TL1 and CLI
support? parameters
No, N/A
USERAOR
parameter
is used
No, value N/A
is derived
from
FTP/defau
lt line
profile.
5-35