I-010G-A Standards Compliance; I-010G-A Special Considerations; I-010G-A Ont Considerations And Limitations - Alcatel-Lucent 7302 Information Manual

14 — I-010G-A unit data sheet
14.10

I-010G-A standards compliance

The I-010G-A indoor ONT is compliant with the following standards:
•
G.983.2 (revised) support for OMCI interface for ONT management and
provisioning
•
G.984.3 support for dynamic bandwidth allocation
•
G.984.3 support for AES with operator enable/disable per port-ID level
•
G.984.3 support for FEC in both upstream and downstream directions
•
G984.4 (standard and revised) support for OMCI interface for ONT management
and provisioning
14.11

I-010G-A special considerations

Upgrade considerations and limitations
Existing ONTs that use 7342 ISAM FTTU releases older than R04.06.xx and
R04.07.xx must be upgraded to use R04.00.10 software while assigned to a PON ID
value smaller than 64. For this purpose, if split ratios larger than 1:64 are being
deployed, you may choose to set aside the first PON ID as a staging point.

I-010G-A ONT considerations and limitations

Table
Considerations and limitations
No support for per VLAN protocol downstream tagging mode
In SVLAN cross-connect tunnel mode:
•
use non-overlapping pbits since the use of the same pbits on two or more VLAN ports results in
a mismatch alarm
•
downstream frames sent with a single tag normally sent out on the user-side as untagged, will
instead be sent as priority tagged
When using CVLAN translation, or when the same queue is used for multiple pbits, the highest pbit
value in the queue in the downstream direction will be selected to stomp the pbit in the packet
Simultaneous configuration of a CVLAN port and an S-Tunnel on the same UNI will only be supported
if these services are provisioned with non-overlapping pbits
The same VLAN port must be used when employing both protocol-based VLAN for PPPoE and
IPoE-based VLANs
When the VLAN is translated, the pbit value must be modified and the highest pbit value is mapped
to that GEM port
When more than one Ethernet port is in VLAN translation mode, or set to flexible mode with IGMP
channels created, the USERSIDE VLAN IDs of those services are different. All downstream multicast
packets will be tagged on the UNI port with VLAN ID of 4094
Maximum use of multicast on 1 Ethernet port at a time
(1 of 2)
14-10 November 2013
14-12 lists the considerations and limitations for I-010G-A ONTs.
Table 14-12 I-010G-A ONT considerations and limitations
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide