Alcatel-Lucent 7302 Information Manual page 650

Intelligent services access manager

Hide thumbs Also See for 7302:

Table of Contents

NTP 113 — Replace a G-010V-P ONT

Safety information

Read the following safety information before replacing the unit.

Use this procedure to replace an G-010V-P ONT.

Deactivate the ONT services (DLP 131). If you are using the SLID feature, this step

is not required. The ONT and the services can remain in service (IS).

Disconnect the VDSL and power cables, if required, from the ONT; see

November 2013

Danger 1 — Contact the local utility company before you connect the

enclosure to the utilities.

Danger 2 — Observe the local and national laws and regulations that

may be applicable to this installation.

Warning — This equipment is ESD sensitive. Proper ESD protections

should be used when removing the fiber access cover of the ONT.

Caution — Keep indoor ONTs out of direct sunlight. Prolonged

exposure to direct sunlight can damage the unit.

Note 1 — The ONT should be installed in accordance with the

applicable requirements of the NEC or CEC. Local authorities and

practices take precedent when there is conflict between the local

standard and the NEC or CEC.

Note 2 — The ONT must be installed by qualified service personnel.

Note 3 — Indoor ONTs must be installed with cables that are suitably

rated and listed for indoor use.

Note 4 — See

G-010V-P detailed specifications

for the temperature ranges for ONTs.

Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02

G-010V-P unit

3FE 55873 AAAA TCZZA

ONT Product Information Guide