Alcatel-Lucent 7302 Information Manual page 401

Parameter Description
cid_allows_from_hd A value specifying whether
r information from the FROM
header may be used in providing
caller ID to the phone set.
Information from
P-Asserted-Identity header is
always used in preference to the
FROM header. This value only has
effect when no
P-Asserted-Identity information
is available. A "yes" means that
the FROM header will be used for
the caller ID if the
P-Asserted-Identity header is not
present in the INVITE message. A
"no" means that, if the
P-Asserted-Identity header is not
present, then no caller ID is
provided to the phone set. The
default value is "no".
All lines of I-240W-S ONT should
be configured the same.
enable_caller_id The same as the
cid_allows_from_hdr parameter
All lines of I-240W-S ONT should
be configured the same.
ansi_caller_id_ext_d Specifies the number of caller ID
igits digits displayed. Only displayed
for GSIP v4.6 and later software.
By default (false) the number of
digits displayed is 10. If set to
true, the number digits displayed
is extended up to 20.
This parameter takes effect only
if the enable_etsi parameter is
disabled (set to false).
allow_unmatched_n This parameter governs behavior
otify to allow a NOTIFY with full dialog
headers (indicating that they are
part of a dialog) to be accepted
by the ONT that does not match
a known SUBSCRIBE dialog. The
contents of such an unmatched
NOTIFY will be ignored. The
default is "no", meaning that a
NOTIFY with full dialog headers
must match a known SUBSCRIBE
dialog or a 481 error will result.
If the parameter is set to yes, the
contents of such an unmatched
NOTIFY will be ignored.
This parameter should not be set
to "yes" if implicit NOTIFY
messages are expected from the
softswitch (for example, no
SUBSCRIBE is performed).
For other devices, the value is no
and cannot be changed.
(13 of 30)
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Mode Mode Device
1 2
Y Y Package
A, B, H,
I-240W-
S ONT
only
Y Y Package
C, D, E,
F, G,
and
I-240W-
S ONT
Y Y Package
A, B, H
only
Does not
apply on
package
C, D,
and E
Y Y Package
A, B, H
only
November 2013
5 — VoIP overview
OMCIv2 TL1 or CLI
support? parameters
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
5-55