Alcatel-Lucent 7302 Information Manual page 393

Parameter Description
service_code_rls A set of one or more service
codes that the user agent
recognizes as a request to
release a consultation call that
was initiated as part of six-way
conference procedures. This
reflects the fact that in typical
dial plans there are two
equivalent ways to dial a given
service code. This is a string. The
value of this property may
include two service codes, each
up to 6 characters long,
separated by white space. The
default is "*43 1143".
If a configured value also
appears in the digit map with an
S modifier then they will be
processed during dialing for the
associated feature. If the value
is not in the digit map with an S
modifier, then the digits will be
treated as normally dialed digits
and not be specially processed.
Use the appropriate enable_XXX
parameter to enable the service
code.
service_code_hold A set of one or more service
codes that the user agent
recognizes as a request to place
the active call on hold. This
reflects that fact that in typical
dial plans there are two
equivalent ways to dial a given
service code. This is a string. The
value of this property may
include up to two service codes
separated by white space.
The default is "*52 1152." In XML
the length can be up to 6
characters. In TL1, the length
can be up to 5 characters
If a configured value also
appears in the digit map with an
S modifier then they will be
processed during dialing for the
associated feature. If the value
is not in the digit map with an S
modifier, then the digits will be
treated as normally dialed digits
and not be specially processed.
Use the appropriate enable_XXX
parameter to enable the service
code.
For other devices, the value is
"*52 1152" and cannot be
changed.
(5 of 30)
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Mode Mode Device
1 2
N Y Package
A, B, H
only
N Y Package
A, B, H
only
November 2013
5 — VoIP overview
OMCIv2 TL1 or CLI
support? parameters
No, value is N/A
derived
from
FTP/default
line profile.
Yes TL1 using
HOLD using
ent-profile-a
cccodes
CLI using hold
using
configure
voice ont
feat-acccode
-prof
5-47