Alcatel-Lucent 7302 Information Manual page 406

5 — VoIP overview
Parameter Description
enable_etsi This parameter controls whether
the ONT acts in accordance with
ETSI or GR requirements for
offering services. A value of
"yes" enables ETSI behavior. The
default is "no".
etsi_ch_release This parameter contains the
value of the consult call service
option code which is used to drop
the active session and resume
held session as a two-way call
ending the consult state. If this
parameter is not configured or is
configured to contain the empty
string, the ONT disables the
functionality.
Valid values are in the form "Rd,
where d represents '0'-'9' or '*' or
'#'. An invalid value causes the
ONT to act as if this parameter
was not configured. This
parameter only has meaning if
the enable_esti parameter is set
to "yes". The default is an empty
string.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
etsi_ch_toggle This parameter contains the
value of the consult call service
option code used to toggle
between two sessions. If this
property is not configured or is
configured to contain the empty
string, the ONT disables this
functionality.
Valid values are in the form "Rd,
where d represents '0'-'9' or '*' or
'#'. An invalid value causes the
ONT to act as if this parameter
was not configured. This
parameter only has meaning if
the enable_esti parameter is set
to "yes". The default is an empty
string.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
(18 of 30)
5-60 November 2013
Mode
1
N
N
N
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Mode Device OMCIv2
2 support?
Y All No, value is
except derived
package from
C, D, E, FTP/default
and line profile.
I-240W-
S ONT
Y All No, value is
except derived
package from
C, D, FTP/default
and E line profile.
Y All No, value is
except derived
package from
C, D, FTP/default
and E line profile.
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
TL1 or CLI
parameters
N/A
N/A
N/A