Recommended Tools - Alcatel-Lucent 7302 Information Manual

NTP 130 — Install an I-010G-U indoor ONT

Recommended tools

The recommended tools for this DLP are:
• #2 Phillips screwdriver
1/4 in. (6 mm) flat blade screwdriver
•
wire strippers
•
fiber optic splicing tools
•
RJ-45 cable plug crimp tool
•
• voltmeter or multimeter
optical power meter
•
Procedure
Use this procedure to install I-010G-U indoor ONTs.
1 Locate the data cable and the corresponding interfaces.
2 Determine the area where the I-010G-U indoor ONT will be installed.
3 Are any of the cables missing or are they located away from the I-010G-U indoor
ONT mounting area?
a
b
NTP 130-2 November 2013
Danger — Observe the local and national laws and regulations that
may be applicable to this installation.
Warning — This equipment is ESD sensitive. Proper ESD protections
should be used when handling the I-010G-U indoor ONT.
Caution — Keep the I-010G-U indoor ONT out of direct sunlight.
Prolonged exposure to direct sunlight can damage the unit.
Note — Observe the following:
The I-010G-U indoor ONT should be installed in accordance with the
•
applicable requirements of the NEC or CEC. Local authorities and
practices take precedence when there is conflict between the local
standard and the NEC or CEC.
The I-010G-U indoor ONT must be installed by qualified service
•
personnel.
I-010G-U indoor ONTs must be installed with cables that are suitably
•
rated and listed for indoor use.
See the I-010G-U ONT unit data sheet documentation for the
•
temperature ranges for this ONTs.
If yes, go to step 4.
If no, go to step 5.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide