Alcatel-Lucent 7302 Information Manual page 873

Intelligent services access manager

Hide thumbs Also See for 7302:

Table of Contents

Considerations and limitations

When using CVLAN translation, or when the same queue is used for multiple pbits, the highest pbit

value in the queue in the downstream direction will be selected to stomp the pbit in the packet

Simultaneous configuration of a CVLAN port and an S-Tunnel on the same UNI will only be supported

if these services are provisioned with non-overlapping pbits

The same VLAN port must be used when employing both protocol-based VLAN for PPPoE and

IPoE-based VLANs

When the VLAN is translated, the pbit value must be modified and the highest pbit value is mapped

to that GEM port

When more than one Ethernet port is in VLAN translation mode, or set to flexible mode with IGMP

channels created, the USERSIDE VLAN IDs of those services are different. All downstream multicast

packets will be tagged on the UNI port with VLAN ID of 4094

Maximum use of multicast on 1 Ethernet port at a time

For C forwarder and S+C CC forwarder, if the VLAN port uses regenerated profiles or regenerated

pbits, then the downstream traffic can only flow with the derived pbits

When either tip or ring is grounded, DGNONTPOTS tip to ground and ring to ground restrictive

measurements are simultaneously reported as 0 ohms

100M half is not supported

Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02

3FE 55873 AAAA TCZZA

ONT Product Information Guide

21 — I-011G-P unit data sheet

November 2013