Alcatel-Lucent 7302 Information Manual page 930

NTP 145 — Install an I-021G-P or I-241G-Q indoor ONT
9 Install the power supply according to manufacturer specifications.
10 Connect the power cable to the power connector.
11 If used, configure the SLID (chapter 6).
12 Verify the ONT LEDs, voltage status, and optical signal levels (DLP 127).
13 Activate and test the services (DLP 128).
14 If necessary, reset the ONT (DLP 126).
15 STOP. This procedure is complete.
NTP 145-4 November 2013
Note — Observe the following:
Units must be powered by a Listed or CE approved and marked
•
limited power source power supply with a minimum output rate of
12 V dc, 1.5 A.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide