Alcatel-Lucent 7302 Information Manual page 1065

Procedure
Use this procedure to replace an I-211M-K or I-211M-L indoor ONT.
1 For an I-211M-L indoor ONT installed in an enclosure, loosen the TELCO 216
security screw and open the TELCO access cover.
2 Deactivate the ONT services (DLP 131).
If you are using the SLID feature, this step is not required. The ONT and the
services can remain in service (IS).
3 Disconnect the ground wire as well as Ethernet, POTS, coaxial, UPS, and power
cables from the ONT (DLP 132). Also, disconnect the fiber optic cable from the
ONT (DLP 133).
Review the location of the ports for the following ONT configurations:
•
•
•
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
NTP 161 — Replace an I-211M-K or I-211M-L indoor ONT
Note — Observe the following:
Alcatel-Lucent does not provide the power cable for I-211M-K and
•
I-211M-L indoor ONT to UPS connection. Use a power cable that
meets NEC requirements and local codes when replacing an ONT.
The ONT should be installed in accordance with the applicable
•
requirements of the NEC or CEC. Local authorities and practices take
precedent when there is conflict between the local standard and the
NEC or CEC.
The I-211M-L ONT supports connection to a power supply by a
•
separate cable (ordered either with the ONT and power supply unit
or independently). This cable connection can support an maximum
separation between ONT and power supply of 100 feet. The
connectors on the cable must be capable of being field-installed and
use the same connector type at both the ONT and power supply
ends.
See the detailed technical specification section in the
•
I-211M-L unit data sheet
Figure NTP 161-1 for the I-211M-K indoor ONT
Figure NTP 161-2 for the I-211M-L ONT within an outdoor enclosure
Figure NTP 161-3 for the I-211M-L ONT within a Just Inside enclosure
for the temperature ranges for these ONTs.
November 2013
I-211M-K and
NTP 161-3