Alcatel-Lucent 7302 Information Manual page 856

NTP 137 — Replace an I-011G-A, I-011G-B, I-110G-A, or I-111G-A indoor ONT
Safety information
Read the following safety information before replacing the unit.
Procedure
Use this procedure to replace an I-011G-A, I-011G-B, I-110G-A, or I-111G-A indoor ONT.
1 Deactivate the ONT services (DLP 131).
If you are using the SLID feature, this step is not required. The ONT and the
services can remain in service (IS).
2 Power down the ONT unit by using the ON/OFF power switch.
3 Disconnect the POTS, Ethernet, coaxial, and power cables from the ONT (DLP 132)
as required. For the location of the ports on the ONT; see Figure
NTP 137-2 November 2013
Danger — Observe the local and national laws and regulations that
may be applicable to this installation.
Warning 1 — This equipment is ESD sensitive. Proper ESD protections
should be used when connecting or removing the cables to or from the
ONT.
Warning 2 — If the coaxial output of the ONT is connected to the
dwelling infrastructure coaxial distribution system, ensure that the
coaxial distribution system is separately grounded. Grounding of the
dwelling coaxial infrastructure shall use Listed grounded devices and
must be installed in accordance with local Codes and Article 800 of the
National Electric Code, ANSI/NFPA 70, following the manufacturers
instructions.
Caution — Keep ONTs out of direct sunlight. Prolonged exposure to
direct sunlight can damage the unit.
Note — Observe the following:
The ONT should be installed in accordance with the applicable
•
requirements of the NEC or CEC. Local authorities and practices take
precedent when there is conflict between the local standard and the
NEC or CEC.
The ONT must be installed by qualified service personnel.
•
See I-011G-A, I-011G-B, I-110G-A, and I-111G-A unit data sheet
•
the unit data sheet for the temperature ranges for this ONT.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
NTP 137-1.
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
in