Alcatel-Lucent 7302 Information Manual page 412

5 — VoIP overview
Parameter Description
etsi_ch_release_hel This parameter contains the
d_call service code to be used to
release the held session during a
consultation call. If this property
is not configured or is configured
to contain the empty string, the
ONT shall disable this
functionality. Valid values shall
be of the form "Rd", where d
represents '0'-'9' or '*' or '#'. An
invalid value will cause the ONT
to act as if this parameter was
not configured. This parameter
only has meaning if the
enable_esti parameter is set to
"yes". The default is an empty
string.
All lines of I-240W-S ONT should
be configured the same (* and #
are not supported on the
I-240W-S ONT).
etsi_activate_call_ A set of one or more service
codes that the user agent will
waiting
recognize as a request to
activate call waiting in ETSI
mode. The value of this property
may include up to two service
codes of six characters each,
separated by white space. This
reflects that fact that in typical
dial plans there are two
equivalent ways to dial a given
service code. The default is
"*43#".
etsi_deactivate_call A set of one or more service
_waiting codes that the user agent will
recognize as a request to
de-activate call waiting in ETSI
mode. The value of this property
may include up to two service
codes of six characters each,
separated by white space. This
reflects that fact that in typical
dial plans there are two
equivalent ways to dial a given
service code. The default is
"#43#".
etsi_interrogate_cal A set of one or more service
l_waiting codes that the user agent will
recognize as a request to
interrogate call waiting active
status in ETSI mode. The value of
this property may include up to
two service codes of six
characters each, separated by
white space. This reflects that
fact that in typical dial plans
there are two equivalent ways to
dial a given service code. The
default is "*#43#".
(24 of 30)
5-66 November 2013
Mode
1
N
N
N
N
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Mode Device OMCIv2
2 support?
Y All No, value is
except derived
package from
C, D, FTP/default
and E line profile.
Y All No, value is
except derived
package from
C, D, E, FTP/default
and line profile.
I-240W-
S ONT
Y All No, value is
except derived
package from
C, D, E, FTP/default
and line profile.
I-240W-
S ONT
Y All No, value is
except derived
package from
C, D, E, FTP/default
and line profile.
I-240W-
S ONT
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
TL1 or CLI
parameters
N/A
N/A
N/A
N/A