Safety Information - Alcatel-Lucent 7302 Information Manual

NTP 109 — Install a B-8102-A or B-8112-A ONT

Safety information

Read the following safety information before installing the unit.
Procedure
Use this procedure to install a B-8102-A or B-8112-A business ONT.
1 Prepare the cables at the site where the ONT will be installed (DLP 100).
2 Mount the business ONT:
a
b
c
3 Review the connection locations shown in Figure
identical to the B-8112-A ONT shown, however it does not have an F-type coaxial
connector.
NTP 109-2 November 2013
Danger 1 — Hazardous electrical voltages and currents can cause
serious physical harm or death. Always use insulated tools and follow
proper safety precautions when connecting or disconnecting power
circuits.
Danger 2 — Make sure all sources of power are turned off and have no
live voltages present on feed lines or terminals. Use a voltmeter to
measure for voltage before proceeding.
Danger 3 — Always contact the local utility company before
connecting the enclosure to the utilities.
Danger 4 — Observe all local and national laws and regulations that
may be applicable to this installation.
Warning 1 — The earth bonding terminal shall be connected to an
approved earth connection before the ac power is applied.
Warning 2 — This equipment is ESD sensitive. Proper ESD protection
must be used when entering the TELCO Access portion of the ONT.
Note — See the ONT technical specification documentation in the
B-8102-A and B-8112-A unit data sheet
If you are not using a fiber storage compartment, see DLP 144.
If you are using a fiber storage compartment (3EM 20293 AA) and a standard
tray mounting bracket (3EM 20425 AA), see DLP 145.
If you are using a fiber storage compartment (3EM 20293 AA) and a class 1
storage tray mounting bracket (3EM 20425 AB), see DLP 146.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
for the temperature ranges.
NTP 109-1.The B-8102-A is the
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide