Subaru Legacy 2002 Service Manual page 3348

Hide thumbs Also See for Legacy 2002:

Table of Contents

2. General Description

¼ Airbag system wiring harness is routed near

the immobilizer control module. All airbag sys-

tem wiring harness and connectors are colored

yellow. Do not use electrical test equipment on

these circuits.

¼ Be careful not to damage airbag system wir-

ing harness when servicing the immobilizer

control module.

¼ While diagnostic items are being checked,

do not operate radios, portable telephones, etc.

which emit electromagnetic waves near or

inside the vehicle.

¼ When ignition switch is being turned ON or

OFF while diagnostic items are being checked,

do not allow keys with different ID codes close

to the ignition switch. If ignition key is in a key

holder, remove it from holder before carrying

out diagnoses.

GENERAL DESCRIPTION

¼ When repeatedly turning ignition ON or OFF

while diagnostic items are being checked, it

should be switched in cycles of "ON" for at

least 5 seconds → "OFF" for at least 8 sec-

¼ If engine fails to start with a registered igni-

tion key, detach ignition key from ignition

switch and wait for approximately 1 second

until immobilizer indicator light begins to flash.

Start engine again.

¼ Before checking diagnostic items, obtain all

keys for vehicle to be checked possessed by

Immobilizer (Diagnostics)

Chapters

Table of Contents