Schlage PIB300 User Manual page 99

Appendix C: Old Board Configuration Information
Wiring Connections
TS-3 Terminals 26 to 15
TS-2 Terminals 14 to 7
Grounding
!
NOTE
!
NOTE
66
Once the Hand Reader is attached to the wall plate the wiring connections to the Hand
Reader can be made (see Figure 17-2).
8 1 26
RS-232 RJ-45
Terminal 1 and the center pin of jack J12 are connected together. Terminal 2 and the
sleeve of jack J12 are connected together.
Use any one of the following ground terminals to make the earth ground connection: 8,
10, 12, 14, 18, 20, 22, 24, or 26. Do NOT use terminal 2 to establish the earth ground
connection; terminal 2 is not directly connected to ground.
WALL
15 14 7 6 1
TS-1 Terminals 6 to 1
Optional Modem
or Ethernet Jack
Top of Hand Reader
Figure 19-7: Wiring Connections and Dip Switches
Wall Plate
Backup Battery
Jumper
5 4 3 2 1
Dip Switches
Top of
Terminal
O F F
O N