Schlage PIB300 User Manual page 72

Service Menu
Navigating the
Service Menu
Service
Commands
The Service Menu commands provide information that helps you determine if the
HandReader is operating properly and within normal operating parameters.
Once you have entered the Service menu, there are three options available for navigating
the command menu system.
#
• Press to enter the command shown on the display.
Yes
*
• Press to step to the next command in the menu.
No
• Press to exit the command menu (pressing any numeric key also exits the
Clear
command menu). If you are in a command's sub-menu, you may have to press
multiple times to completely exit the command menu.
There are three commands available from the Service command menu.
• Calibrate – Run calibration to check HandReader exposure values.
• Status Display – Check the status of HandReader inputs and outputs, the hand read
score of the last user to verify on the system.
• Network Status – Check the network communication status of HandReaders in the
HandKey system (master HandReader only).
Refer to and identify the commands you need to perform. Step through all previous
commands until you reach the desired command. All commands are listed in menu order.
Table 11-6: Service Command Menu
Service Menu
Password = 1
Calibrate
Recal (N/Y)
Status Display
On/Off (Y/N)
Network Status
Status Information
Clear
39