Schlage PIB300 User Manual page 51

Mechanical Installation
Mounting the
Wall Plate
Routing the
Wiring
18
5. For a solid wall, hold the wall plate against the wall, centering the leveling hole over
the mark in the wall.
6. Align a bubble level with the top edge of the wall plate and gently rotate the wall plate
until the bubble level shows that the top edge of the wall plate is level.
7. Secure the plate to the wall using heavy masking tape.
8. Using the wall plate as a template, mark the locations of the two upper screw holes
and the three lower screw holes.
9. For a concealed wiring connection, trace the outline of the open area in the center
of the wall plate. Identify and mark a 1/2 inch hole through which the HandReader's
wiring will be mounted.
10. For a surface conduit wiring connection, mark the two conduit clamp holes at the right
side of the wall plate.
11. Remove the wall plate, masking tape, and the nail (if used).
1. For a hollow wall, use the provided hardware to mount the wall plate. Use the two
auger style fasteners for the upper two mounting holes. Use the toggle bolts for the
three lower mounting holes.
2. For a solid wall, use expansion bolts to mount the wall plate. For all five mounting
holes, drill a 1/4 inch diameter hole, 1/4 of an inch deeper than the length of the
expansion anchor.
1. For a concealed wiring connection, drill a 1/2 inch hole in a convenient location within
the open area of the wall plate. Pull the wiring to enter the HandReader through this
hole in the open area.
2. For a surface conduit wiring connection, drill a 1/4 inch diameter hole, 1/4 of an inch
deeper than the length of the expansion anchor for each of the two conduit clamp
holes. Route 1/2 inch conduit to the HandReader, ending the conduit between the two
conduit clamp holes. Pull the wiring to enter the HandReader through the conduit.