Schlage PIB300 User Manual page 62

WALL TO WHICH
THE HAND READER
IS ATTACHED
12 to 24 V
AC/DC
Input
18 17 16 15
1 2
RS-422
Connection
TOP OF THE
HAND READER
* These components are not supplied by Schlage Biometrics, Inc.
All HandReaders in a network must be set to the same communication method. Four-wire
RS-422 cabling is required for HandNet for Windows™ network installations. Schlage
Biometrics does not recommend two-wire RS-485 cabling for new network installations.
*Serial Printer
14 13 12 11 10 9 8 7
Figure 7-8: Printer to HandKey II Wiring Diagram
HandKey II Manual
6 5 4 3 2 1
J4
RS-232 Jack
HINGE
4 Pin
Connector
29