Schlage PIB300 User Manual page 100

Wiring
Examples
SWITCH INPUTS
7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26
EARTH GROUND
There are two standard methods for providing earth grounding to HandPunch units:
• earth grounding all units (see page 10)
• carrying an earth ground to each unit (see page 11)
Earth ground all units when there is a good earth ground source near each unit and/or
when there are very long cable runs between units.
Carry an earth ground to each unit when there are no earth grounds convenient to the
unit and the unit's power supply is floating.
The following Tables provide the pin outs for the terminal strips on the Hand Reader.
• Table 17-1 on page 68 provides the pin outs for TS-1: Power and Communication
Connections.
• Table 17-2 on page 68 provides the pin outs for TS-2: Input Connections.
• Table 17-3 on page 68 provides the pin outs for TS-3: Card Reader and Output
Connections.
• Table 17-4 on page 68 provides the pin outs for the RJ-45 Serial RS-232 Connection.
The following Figures provide typical Hand Reader wiring diagrams.
• Figure 17-3 on page 67 provides connection points for ground
• Figure 17-4 on page 69 provides a typical Lock Output wiring diagram.
• Figure 17-5 on page 70 provides a typical Auxiliary Output wiring diagram.
• Figure 17-6 on page 71 provides a typical Card Reader Emulation Mode wiring diagram.
• Figure 17-7 on page 72 provides a typical RS-422 Master/Remote Network System
wiring diagram.
• Figure 17-8 on page 73 provides a typical RS-485 2-Wire Master/Remote Network
System wiring diagram.
• Figure 17-9 on page 74 provides a typical Host PC Network System wiring diagram.
• Figure 17-10 on page 75 provides a typical Printer to Hand Reader wiring diagram.
CARD
READER
OUTPUTS
INPUT
CONNECTION PINS
Figure 19-8: Earth Ground Connection Terminals
HandKey II Manual
67