Schlage PIB300 User Manual page 101

Appendix C: Old Board Configuration Information
68
Table 19-13: TS-1 - Power and Communication Connections
Terminal Connection
1 Power Input 12 to 24 VDC/VAC
2 Power Return
3 RS-422 Rx- or RS-485 Rx-/Tx-
4 RS-422 Tx- or RS-485 Rx+/Tx+
5 RS-422 Rx+
6 RS-422 Tx+
Table 19-14: TS-2 - Input Connections
Terminal Connection
7 Request to Exit Input
8 Ground
9 Door Monitor Switch Input (NC Standby)
10 Ground
11 Auxiliary Input 1
12 Ground
13 Auxiliary Input 2
14 Ground
Table 19-15: TS-3 - Card Reader and Output Connections
Terminal Connection
15 +5 VDC @ 400 mA Max. Output for External Card Reader
16 Card Reader: Wiegand D0 or Magnetic Stripe Data Input
17 Card Reader: Wiegand D1 or Magnetic Stripe Clock Input
18 Card Reader Ground
19 Lock Output or Wiegand D1 or Magnetic Stripe Clock Output
20 Ground
21 Auxiliary Output 0 or Wiegand Data 0 or Magnetic Stripe Data Output
22 Ground
23 Auxiliary Output 1
24 Ground
25 Auxiliary Output 2
26 Ground
Table 19-16: RJ-45 Serial RS-232 Connection
Pin Signal
1 RI
2 CD
3 DTR
4 GND
5 Rx Data
6 Tx Data
7 CTS
8 RTS
* These signals are not currently supported.
Connection
* Ring Indicator Input (from external device)
* Carrier Detect Input (from external device)
* Data Terminal Ready Output (to external device)
Ground
Receive Data Input (from external device)
Transmit Data Output (to external device)
* Clear to Send Input (from external device)
* Ready to Send Output (to external device)