Front Cushion Construction - Honda ST50 1969 Shop Manual

36
c. Rt'llsscmbly
(!) Wash the cone races, ball races and thcstcol
balls, and pack with new grease. Use re-
commended fibergrca.,;e.
(2) In order to provide proper stecrability, the
stceringstemnutshouldbctorqucdasfollow.
I. Fasten the nut completely until it is
is locked.
2. Release the nut about 45 degrees co-
untcrcclockwisc.
3. Fasten
it
by hand unti l
it
is locked
again.
4. Release it by hand. Proper stecrability
will
then be provided.
4,.3 F r ont Cus hi on
Fl1.63
• · Front Cushion Construction
The
front wheel ax le and axle nlll assembles the cast aluminum hub consisting of two sets of 63010 radial ball
bearings and an integral brake drum to the front brake panel which contains the brake shoes and spc,cdomcter
gea r. The front cushion, unlike the other types with a damper inside, has only a coil spring for cushion
cffcct,consideringt hc usage of this type.
.....
b. Oi.5a5sembly
(I) Removethefrontwhec l (seepageJS).
(2) Remove the front fork lop bridge (see page
30).
(3) Both fron t cushions can be pulled out from
the bottom of the front cushion housi ng
incorpora1ed on the steering stem after re-
leasing the fronl fork guide cap (Fig. 64)
shows the front cushion assembly,