Starter Motor - Honda CB HORNET 160R 2015 Shop Manual

ALTERNATOR
Install the clutch cover and starter clutch assembly to the
flywheel, aligning the bolt hole of cover, starter clutch and
flywheel.
Hold the flywheel using the flywheel holder.
TOOL:
Flywheel holder
Clean and apply a locking agent to the stater clutch bolts
threads.
Install and tighten the starter clutch bolts to the specified
torque.
TORQUE: 16 N.m (1.6 kgf.m, 12 Ibf.ft)
Apply clean engine oil to the starter driven gear teeth.
Install the starter driven gear to the flywheel while turning
the driven gear counterclockwise.
Make sure that the starter driven gear turns counter
clockwise smoothly and does not turn clockwise.
Install the flywheel (page 10-5).

STARTER MOTOR

REMOVAL
Slide the rubber cap off the starter motor terminal, and
remove the terminal nut and starter motor cable.
Remove the two mounting bolts, ground cable and starter
motor from the crankcase.
10-8
070SRTKSP015
CLUTCH COVER
STARTER CLUTCH
ASSEMBLY
BOLTS
STARTER MOTOR
RUBBER CAP
CABLE
GROUND
CABLE
BOLTS
FLYWHEEL
HOLDER
STARTER
DRIVEN GEAR
TERMINAL NUT