Displaying And Maintaining Port Security; Port Security Configuration Examples; Configuring The Autolearn Mode - HP 3600 v2 Series Security Configuration Manual

Follow these steps to configure a port to ignore the authorization information from the RADIUS server:
To do...
Enter system view
Enter Layer 2 Ethernet interface
view
Ignore the authorization
information from the RADIUS
server

Displaying and maintaining port security

To do...
Display port security configuration
information, operation
information, and statistics about
one or more ports or all ports
Display information about secure
MAC addresses
Display information about blocked
MAC addresses

Port security configuration examples

Configuring the autoLearn mode

Network requirements
See Figure 88. Configure port Ethernet 1/0/1 on the Device, as follows:
Accept up to 64 users on the port without authentication.
•
Permit the port to learn and add MAC addresses as sticky MAC addresses, and set the sticky MAC
•
aging timer to 30 minutes.
After the number of secure MAC addresses reaches 64, the port stops learning MAC addresses. If
•
any frame with an unknown MAC address arrives, intrusion protection starts, and the port shuts
down and stays silent for 30 seconds.
Use the command...
system-view
interface interface-type
interface-number
port-security authorization ignore
Use the command...
display port-security [ interface
interface-list ] [ | { begin | exclude
| include } regular-expression ]
display port-security mac-address
security [ interface interface-type
interface-number ] [ vlan vlan-id ]
[ count ] [ | { begin | exclude |
include } regular-expression ]
display port-security mac-address
block [ interface interface-type
interface-number ] [ vlan vlan-id ]
[ count ] [ | { begin | exclude |
include } regular-expression ]
210
Remarks
—
—
Required
By default, a port uses the
authorization information from the
RADIUS server.
Remarks
Available in any view
Available in any view
Available in any view