Omron FH series User Manual page 506

SGRSAVE
Saves scene group data.
<Command format>
<Response format>
When processing is performed normally
When processing is not performed normally
<Parameters explanation>
Scene group No.
Destination
*1: Do not specify a save destination other than RAMDisk or External memory, i.e. C:\ProgramFiles\FZ
The saved Scene data area may be reduced and the Sensor Controller will not perform correctly.
IMPORTANT
• If the specified file name already exists, this existing file will be overwritten.
• Do not turn off power of the Sensor Controller until return the response.
• For the FH/FZ5-1100 series, do not save to a non-volatile area on the C drive (such as C:\ProgramFiles\FZ). This would
reduce the storage area for scene data etc. and make correct operation impossible.
(Example)
When you save the following case:
• Scene group number: 3
• SCNSAVE file name: LABEL.SGP
• Drive name: USBDisk2
• Folder name of the external memory: IMG01
<Command>
<Response>
504
Command Control
Specifies the scene group No. to save (0 to 31).
The name of the file containing the Scene Group data you wish to save.
Specify the folder name as an absolute path.
The file name needs the "SGP" extension.
The save destination folder differs depending on the Sensor Controller series.
Save destination FH series/FZ5-1100 series
RAMDisk C:\Data\RAMDisk
External memory E:\, F:\, G:\, H:\, M:\ (FH series only)
\ \
*1
\
Vision System FH/FZ5 Series User's Manual
FZ5-L series/FZ5-600 series
\RAMDISK
\USBDisk to \USBDisk3
for Communications Settings (Z342)