Omron FH series User Manual page 494

Sets the state of specified parallel I/O terminal
Sets the specified parallel I/O terminal: ON/OFF
Specifies the Parallel terminal with a combination of terminal type, terminal number and terminal status.
For how to set, refer to the following contents or example.
Example)
When you want to set the parallel terminal status of Line 0 except DO to turn ON at once.
1. Sends the get command the parallel terminal status at once to the port number which set on the Line 0.
2. The parallel terminal status except DI is responded.
<Command format>
or
<Response format>
When processing is performed normally
When processing is not performed normally
<Parameters explanation>
Terminal types
Terminal number
Terminal state
492
Command Control
Set the terminal by combining Terminal number. Specified terminal differ according to the Sensor
Controller series. For detail, refer to
Set the terminal by combining Terminal type. Specified terminal differ according to the Sensor
Controller series. For detail, refer to
0: OFF
1: ON
*1
.
*1
.
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)