Omron FH series User Manual page 403

Hide thumbs Also See for FH series:

Table of Contents

Set All Parallel DO Terminal Statuses

Sets the ON/OFF status of all Parallel DO terminals at once.

For how to set, refer to the following:

When you want to set the Parallel DO terminals status of Line 0, to ON at once:

1. Set the terminals status ON to the desired assignment BIT of the Parallel DO terminal status.

2. Send the specified command which set step 1 to the port number of Line 0.

3. Executed result of command is responsed.

Command (PLC to Sensor Controller)

First word in

Command Area

Response (Sensor Controller to PLC)

First word in

Response Area

Vision System FH/FZ5 Series User's Manual

for Communications Settings (Z342)

Command code

Terminal state

Parallel terminal status (0: OFF / 1: ON) is

assigned to BIT of Terminal state.

This assignment differ according the Sensor

Controller series or used Lines.

For more details, refer to

Command code

Response target command codes

Response code

Command execution result

OK: 0(0000 0000)

NG: Not 0 (0000 0000)

Command Control

Troubleshooting