Omron FH series User Manual page 492

PARAPORTCOND or PPC
Gets the specified status of parallel I/O
Gets the ON/OFF information of specified parallel I/O terminal.
Specify the parallel terminal with combination of terminal type and terminal number.
For how to set, refer to the following:
Example)
When you want to get the terminal status of STEP0 and Line0
1. Set [0] in terminal type, [STEP] is specified.
2. Set [0] in terminal number, [STEP0] of [Line0] are specified.
3. Sends the specified command which set the above step 1 and 2 to the port number of Line 0.
4. Responses the specified terminal status.
<Command format>
or
<Response format>
When processing is performed normally
When processing is not performed normally
<Parameters explanation>
Terminal type
Terminal number
Terminal state
*1: Terminal type and Terminal number
FH-1000 series/FH-3000 series Sensor Controller
Terminal type
STEP
DSA
DI
DI_LINE 11
490
Command Control
Set the terminal by combining Terminal number. Specified terminal differ according to the Sensor
Controller series. For detail, refer to
Set the terminal by combining Terminal type. Specified terminal differ according to the Sensor
Controller series. For detail, refer to
0: OFF
1: ON
0 1
0 STEP0 STEP1
1 DSA0 DSA1
2 DI0 DI1
DILINE0 DILINE1
*1
.
*1
.
Terminal number
2 3
STEP2 STEP3 STEP4
- - -
DI2 DI3 DI4
DILINE2 - -
Vision System FH/FZ5 Series User's Manual
4 5 6
STEP5 STEP6
- -
DI5 DI6
- -
for Communications Settings (Z342)
7
STEP7
-
DI7
-