Omron FH series User Manual page 231

Settings in the Sensor Controller (Device Parameter Settings)
1
Right-click the Sensor Controller in the network on the Network Configurator and select
[Parameter] − [Edit].
2
The Edit Device Parameters Dialog Box will be displayed. Make the required settings.
Parameter name
*1
001 Input Size
*2
002 Output Size
*3
003 RPI
*1: Although the data size can be set as high as 502 bytes, use the above settings.
*2: Although the data size can be set as high as 502 bytes, use the above settings.
*3: The packet interval (RPI) is set in the connection settings between the PLC and the Sensor. No setting is required here.
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)
Value
Total size of Response Area, Data
Output Area, and User Input Area.
Total size of Command Area and
User Input Area.
The requested packet interval
Set value
Set one of the following values.
When [Result Data Format 0] is selected under Output
data size:
48 bytes (without using the user area)
80 bytes (with using the user area)
When [Result Data Format 1] is selected under Output
data size:
80 bytes (without using the user area)
112 bytes (with using the user area)
When [Result Data Format 2] is selected under Output
data size:
144 bytes (without using the user area)
176 bytes (with using the user area)
When [Result Data Format 3] is selected under Output
data size:
272 bytes (without using the user area)
304 bytes (with using the user area)
Set either of the following values.
20 bytes (without using the user area)
52 bytes (with using the user area)
10000
Communicating with EtherNet/IP
2
229