Omron FH series User Manual page 397

Response (Sensor Controller to PLC)
First word in Command
Response Area code
+2 7020
+3 0030
+4 -
+5 -
Set Parallel Terminal Status
Sets the specified parallel I/O terminal: ON/OFF
Specifies the Parallel terminal with a combination of terminal type, terminal number and terminal status.
For how to set, refer to the following:
Example)
When you want to set the OR3 of Line3 status.
1. Set [6] in terminal type, [OR] is specified.
2. Set [3] in terminal number, [OR3] is specified.
3. Set [1] in terminal status, [OR3] terminal is specified to turn ON from OFF.
4. Send the specified command which set the above step 1 to 3 to the port number of Line 3.
5. Executed result of command is responsed.
Command (PLC to Sensor Controller)
First word in Command
Command Area code
+2 8010
+3 0030
+4 -
+5 -
+6 -
+7 -
+8 -
+9 -
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)
Bit
12 to 15 8 to 11 4 to 7
0111 0000 0010
0000 0000 0011
0000 0000 0000
0000 0000 0000
Bit
12 to 15 8 to 11 4 to 7
1000 0000 0001
0000 0000 0011
0000 0000 0000
0000 0000 0000
0000 0000 0000
0000 0000 0000
0000 0000 0000
0000 0000 0000
0 to 3
0000
Command code
Response target command codes
0000
0000 Response code
Command execution result
OK: 0(0000 0000)
0000
NG: Not 0 (0000 0000)
0 to 3
0000
Command code
0000
0000 Terminal type:
Set the terminal by combining Terminal number.
Specified terminal differ according to the Sensor
0000
Controller series. For detail, refer to
0000 Terminal number:
Set the terminal by combining Terminal type.
Specified terminal differ according to the Sensor
0000
Controller series. For detail, refer to
0000
Terminal status:
Set the specified terminal status. (0: OFF/1: ON)
0000
Description
Description
*1
.
*1
.
Command Control
3
395