Output Format - Omron FH series User Manual

Output Format

If the processing unit [Data Output] is set in a scene, measurement results are sequentially output starting from
the smallest data No. set in [Setting] of [Data Output]. You can also place more than one Data Output Unit in the
measurement flow. You can then use record separators to identify the data for individual Data Output Units.
Reference: Output Format (Data Output) (p.282)
Outputting ASCII Data
Set the output format as [ASCII] in [Output form] of the [Data Output] processing item.
The default setting is [ASCII].
Output Format
Note
The output format, number of digits, data separator, etc., can be changed if necessary.
Refer to Output Data Settings (Processing Item Registration) (p.279)
Example: Integer digits: "5 digits", decimal places: "3 digits", negative numbers: "-", field separator: "comma",
record separator: "delimiter"
Note
• Field separators are not output if there is no following data.
• Lower decimal digits are rounded up before the data is output.
The range of values that can be output is as follows:
−999999999.9999 ≤ Measurement value ≤ 999999999.9999
When measurement value < −999999999.9999, "−999999999.9999" is output.
When measurement value > 999999999.9999, "999999999.9999" is output.
When JG (Judgement) is set, the next values are output.
OK: 1
NG: −1
Note
After the measurement is completed, data output will not stop until all of the data is output. Data output will not be
interrupted.
296
Non-procedure Communications Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)