Omron FH series User Manual page 302

Note
If the operation mode is set to Multi-line Random-trigger Mode and the number of lines to use simultaneously was
increased, the signals, control, and output that can be performed is different from when only a single line is used, as
described in the following table.
For the signals that can be used and for differences in assignments, refer to
Signal Specifications (p.325).
FH-1000/FH-3000 series Sensor Controller
Number of
controlled lines
2 lines
3 or 4 lines
5 to 8 lines
FZ5-1100 series Sensor Controller
Number of
controlled lines
2 lines
3 to 8 lines
300
Parallel Communications
Differences from when only a single line is used (i.e., when the operation mode is not
• The usable functions are the same as for when only a single line is used.
• DO signals are divided as follows: Line 0: DO0 to DO7, Line 1: DO8 to DO15
• Parallel data output and parallel judgement output cannot be performed (DO signals
cannot be used).
• Handshaking output cannot be used (the GATE signal and DSA signal cannot be used).
• An encoder cannot be used.
• The RUN signal cannot be used. The same ERR signal is used for all lines.
• Parallel data output and parallel judgement output cannot be performed (DO signals
cannot be used).
• Handshaking output cannot be used (the GATE signal and DSA signal cannot be used).
• An encoder cannot be used.
Differences from when only a single line is used (i.e., when the operation mode is
not set to Multi-line Random-trigger Mode)
• The RUN signal cannot be used. The same ERR signal is used for all lines.
• DO signals are divided as follows: Line 0: DO0 to DO7, Line 1: DO8 to DO15
The FZ5 does not support using 3 to 8 lines (operation will not be dependable).
Multi-line Random Trigger Mode
set to Multi-line Trigger Mode)
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)