Omron FH series User Manual page 488

Sets all parallel terminal states at once, except for DO terminals
Sets the ON/OFF status of all Parallel terminals except for DO terminals.
For how to set, refer to the following:
Example)
When you want to set the Parallel DO terminals status of Line 0, to ON at once:
1. Set the terminals status ON to the desired assignment BIT of the Parallel DO terminal status.
2. Send the specified command which set step 1 to the port number of Line 0.
3. Executed result of command is responsed.
<Command format>
or
<Response format>
When processing is performed normally
When processing is not performed normally
<Parameters explanation>
Terminal state
486
Command Control
Terminal status
0: OFF
1: ON
For assigned terminal to each bit, refer to
*1
.
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)