Communications Setup Procedures - Omron FH series User Manual

Communications Setup Procedures

The following settings are required to use non-procedure communications.
1. Communications Module settings
(startup settings)
↓
2. Communications specifications settings · · · The communications specifications are set for the communications method
↓
3. Output data settings (processing item
registration)
↓
4. Testing communications
270
Non-procedure Communications
· · · The communication method to be used is determined by selecting a com-
munication module.
Reference: Communications Module Settings (Startup Settings) (p.271)
of the Communications Module that was selected in step 1.
Reference: Communications Specifications Settings (p.272)
Set the data to output and register it in an Output Unit.
· · ·
The Output Unit is placed in the measurement flow in the same way as for
other processing items.
Reference: Output Data Settings (Processing Item Registration) (p.279)
· · · If communications are not working properly, check the communications
setup from step 2 and perform a communications test to determine if the
Sensor Controller can be detected on the network.
If that does not solve the problem, refer to the troubleshooting section.
Reference: Testing Communications (p.285)
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)