Omron FH series User Manual page 102

Error Details
This section provides details on errors.
Interpreting Error Descriptions
The items that are used to describe individual errors (events) are described in the following copy of an error
table.
Event name Gives the name of the error.
Meaning Gives a short description of the error.
Source Gives the source of the error.
Error attributes Level
Effects User program
This is the status of the indicators for the EtherCAT port that is built into the NJ-series Controller. Indicator status is
Indicators
given only for errors in the EtherCAT Master Function Module and the EtherNet/IP Function Module.
Variable
System-defined
Lists the variable names, data types, and meanings for system-defined variables that provide direct error notifica-
variables
tion, that are directly affected by the error, or that contain settings that cause the error.
Assumed cause
Cause and
correction
Lists the possible causes, corrections, and preventive measures for the error.
Attached
This is the attached information that is displayed by the Sysmac Studio or an NS-series PT.
information
Precautions/
Provides precautions, restrictions, and supplemental information.
Remarks
*1: One of the following:
Major fault: Major fault level
Partial fault: Partial fault level
Minor fault: Minor fault level
Observation
Information
*2: One of the following:
Automatic recovery: Normal status is restored automatically when the cause of the error is removed.
Error reset: Normal status is restored when the error is reset after the cause of the error is removed.
Cycle the power supply: Normal status is restored when the power supply to the Controller is turned OFF and then back
ON after the cause of the error is removed.
Controller reset: Normal status is restored when the Controller is reset after the cause of the error is removed.
Depends on cause: The recovery method depends on the cause of the error.
*3: One of the following:
System: System event log
Access: Access event log
*4: One of the following:
Continues: Execution of the user program will continue.
Stops: Execution of the user program stops.
Starts: Execution of the user program starts.
100
EtherCAT Connections (FH-1000 series/FH-3000 series only)
Source details
Tells the level of
influence on con- Recovery
*1
trol.
Tells what will
happen to execu-
Operation
tion of the user
*4
program.
Data type
Correction
Event code Gives the code of the error.
Gives details on
the source of the Detection timing
error.
Gives the recov-
Log category
*2
ery method.
Provides special information on the operation that results
from the error.
Name
Prevention
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)
Tells when the
error is detected.
Tells which log the
error is saved
*3
in.