Fspf Retransmit-Interval - Cisco MDS 9000 series Command Reference Manual

Chapter 8 F Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

fspf retransmit-interval

To specify the time after which an unacknowledged link state update should be transmitted on the
interface, use the fspf retransmit-interval command. To revert to the default value, use the no form of
the command.
Syntax Description seconds
vsan vsan-id
Defaults
5 seconds
Command Modes Interface configuration submode.
Command History Release
1.1(1)
Usage Guidelines
Access this command from the
This value must be the same in the ports at both ends of the ISL.
Note
Examples The following example specifies a retransmit interval of 6 seconds after which an unacknowledged link
state update should be transmitted on the interface for VSAN 1.
switch# config terminal
switch(config)# interface fcip 1
switch(config-if)# fspf retransmit-interval 6 vsan 1
Related Commands Command
show fspf interface
show interface fcip
OL-8413-07, Cisco MDS SAN-OS Release 3.x
fspf retransmit-interval seconds vsan vsan-id
no spf retransmit-interval seconds vsan vsan-id
Modification
This command was introduced.
Description
Displays information for each selected interface.
Displays an interface configuration for a specified FCIP interface.
Specifies FSPF retransmit interval in seconds. The range is
1 to 65535.
Specifies a VSAN ID. The range is 1 to 4093.
submode.
switch(config-if)#
Cisco MDS 9000 Family Command Reference
fspf retransmit-interval
8-81