System Default Zone Mode Enhanced - Cisco MDS 9000 series Command Reference Manual

system default zone mode enhanced

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
system default zone mode enhanced
To configure the zone mode default value as enhanced, use the system default zone mode enhanced
command in the configuration mode. To configure the zone mode default value as basic, use the no form
of the command.
Syntax Description This command has no other arguments or keywords.
Defaults None.
Command Modes
Configuration mode.
Command History Release
3.2(1)
Usage Guidelines This command is used to configure the default value of zoning mode as basic or enhanced. The default
value of zoning mode is used when a VSAN is newly created. If the VSAN is deleted and recreated, the
value of the zoning mode will default to the value specified by the configuration.
The default zone mode can be configured using the setup script. Select the basic or enhanced default
Note
zone mode configuration when the switch is reloaded after you enter the write erase command.
Examples The following example shows how to configure the zone mode default value as enhanced.
switch# config
switch# system default zone mode enhanced
The following example shows how to configure the zone mode default value as basic.
switch# config
switch# no system default zone mode enhanced
Related Commands Command
=
show system default
zone
Cisco MDS 9000 Family Command Reference
21-82
system default zone mode enhanced
no system default zone mode enhanced
Modification
This command was introduced.
Description
Displays the default value of zone mode as basic and enhanced.
Chapter 21 S Commands
OL-8413-07, Cisco MDS SAN-OS Release 3.x